compressor

[wareagle2]

Anyone have any pros or cons on the Iwata powerjet compressor as far as using it for one or two setups and doing auto designs?


wareagle:hunter:

[JimmyG]

Howdy Wareagle.....I'm moving your thread to the Airbrushes and Compressors forum section so we can get you some specific replies.....

I will start it off with adding a link to the Iwata Powerjet compressor....
http://www.iwata-medea.com/products/compressors/power_info.jsp

The Iwata PowerJet Pro compressor is specifically set up for two stations...You may want to consider this one instead....
http://www.iwata-medea.com/products/compressors/pro_info.jsp

[AndyW]

Have heard they are very good compressors, but that is my total knowledge of these. A lot of people tend to move up to a compressor with a tank for multiple gun set ups and also to give the ability to run bigger guns because of the air requirements needed.

[Shiva]

you doing your own clear? need a LOT bigger compressor then.
1.2 cfm is not much capacity for a bigger gun.
I got a little touch up gun, needs 5 cfm at 25psi.

[ARTSPRAYJ4J]

iwata airbrush compressors are made for them by Sparmax they also supply Simair ,check out the prices on each supplier as you will find Iwata charge more than the others for exactly the same units wink wink


paul